Knee Biomechanics

From WikiMSK

Revision as of 19:47, 1 August 2021 by Jeremy (talk | contribs) (Created page with "This article discussed knee biomechanics, for a discussion on the anatomy of the joint see Knee Joint. ==Movement== '''Tibiofemoral Joint Movement''' *'''Sagit...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This article discussed knee biomechanics, for a discussion on the anatomy of the joint see Knee Joint.

Movement

Tibiofemoral Joint Movement

  • Sagittal plane motion dominates along with quadriceps muscle group action.
    • The typical range of motion is from 3° of hyperextension to 155° of flexion. In cultures where squatting is common flexion can reach beyond 155°.
  • Rotation is restricted by the interlocking of the femoral and tibial condyles. This is because the medial femoral condyle is longer than the lateral condyle; and also because there is tightening of the collateral ligaments, ACL, and posterior capsule.
    • Rotation is maximum at 30-40° of flexion where external tibial rotation is approximately 18° and internal tibial rotation is approximately 25°. Rotation is constant up to approximately 120° of flexion and then reduces up to full flexion due to soft tissue tightening.
  • Frontal plane (abduction/varus and adduction/valgus).
    • At full extension there is almost no frontal plane motion. Passive frontal plane motion increases with knee flexion up to 30°, but only up to a few degrees. With flexion past 30° there is reduced frontal plane motion due to soft tissue limitation.
  • For normal activities of daily living a range of motion of 117° of flexion is required. However squatting and kneeling require higher ranges of motion. During gait, the range of flexion needed increases from 0-6° with slow walking up to 18-30° with running.
  • There is sliding throughout the range of motion. Medially there is sliding with a close to constant contact point on the tibia. Laterally there is rolling and sliding as the contact point on the tibia moves posteriorly.

Patellofemoral Joint Movement

  • Surface motion occurs primarily in the sagittal plane with respect to axes fixed in the femur.

Stability

  • Anterior Cruciate Ligament
    • predominant restraint to anterior tibial displacement. Resists 75% of anterior force at full extension and addition 10% up to 90° of knee flexion.
  • Posterior Cruciate Ligament
    • Primary restraint to posterior tibial translation. Resists 85-100% of posterior force at both 30° and 90° of knee flexion. Secondary stabiliser for rotation at high flexion angles.
  • Lateral Collateral Ligament
    • Primary restraint to varus angulation. Resists 55% of applied load at full extension
  • Medial Collateral Ligament
    • Superficial portion is primary restraint to valgus angulation. Resists 50% of applied valgus load. Capsule, ACL, and PCL share remaining valgus load.
    • MCL along with ACL also resists rotation at 20-40°of knee flexion.
    • Limits AP displacement of medial femoral condyle and provides medial pivot action in function.
  • Knee opens with varus moments with opening of the lateral knee more so than on the medial side. The MCL is paradoxically weaker than the LCL, but the ITB helps to dynamically stabilises the lateral side.
  • Muscle contraction and co-contraction of quadriceps and hamstrings contribute to knee stability by increasing the stiffness.
  • Scree-home mechanism of the tibiofemoral joint in extension adds stability in full extension. The tibia rotates externally and the contact point shifts anteriorly which acts as a brake to further extension and provides a stable knee posiion.

Patella Function

  • Lengthens the lever arm of the quadriceps muscle force about the centre of rotation of the knee, increasing the mechanics and efficiency of the quadriceps.
  • Quadriceps muscle force increases with knee flexion to counterbalance flexion moment, starting from minimal quadriceps action with standing. The torque around the patellofemoral joint is increased with flexion.
  • Quadriceps and ligament forces aren't parallel, which produces a laterally directed force on the patella, putting it at risk of laterally subluxing.
    • This is prevented by the slope and height of the patella groove on the lateral side, while the medial groove is shallow.
    • At flexion beyond approximately 90° the patella sinks into the intercondylar notch which has high slopes laterally and medially.
  • With knee extension, the lower aspect of the patella sits against the femur. With flexion to 90° the contact between the patella and femur moves cranially and increases in area With a tight ITB, the patellofemoral joint force can shift laterally.

See Also